Project "Back to Skool" my old high school mini rebuild
12884 views
153 replies
52 following
K
Project "Back to Skool" my old high school mini rebuild
bagged95s10
+1y
Got the idler arm mount built and have a LSOH steering linkage kit on the way. So that wraps up the front other than some grinding and smoothing the curves out. Got both front body mounts made and welded n place. Next Ill do the rear mounts and then cut it loose from the table, flip and weld out the bottom. Then install the wishbone lower links and bag mounts and driveshaft hoop and she'll be a roller.
Master Fabber
+1y
Please do not take this in a bad way. Your frame looks badass, but you should have just built a new front suspension, you definitely have the fab skills! Just jig off of the stock mounting points and do your own box tube crossmember and rails there. Would flow so much better with the rest of your frame. Good Luck looks great. JR
tuckinlugs06
+1y
yeah i was gonna say the same
bagged95s10
+1y
No offenses taken. I had thought about it actually but when all the holes are filled and and the x memebers is smooth it won't look bad. It does look kinda odd because its bulky but the small block will cover that up
Maybe I'll get a wild hair and ditch it anyways.
Maybe I'll get a wild hair and ditch it anyways.
DeepSouthS10
+1y
Edited: 10/18/2012 12:49:13 AM by DeepSouthS10
--------------------------------------------
bagged95s10 said:
...ordered some frame curves like I used in the rear gonna make the front sweep down and around like the rear and fab up some mounts for idler arm and steering box
--------------------------------------------
where could i order said frame curves?
--------------------------------------------
bagged95s10 said:
...ordered some frame curves like I used in the rear gonna make the front sweep down and around like the rear and fab up some mounts for idler arm and steering box
--------------------------------------------
where could i order said frame curves?
bd94s10
+1y
Lookin' great!
DeepSouthS10
+1y
nevermind i think i found them at Welder Series Inc. They are pretty nifty. Certainly makes the idea of building a frame a little less intimidating.
bagged95s10
+1y
Thanks Jason
--------------------------------------------
DeepSouthS10 said:
nevermind i think i found them at Welder Series Inc. They are pretty nifty. Certainly makes the idea of building a frame a little less intimidating.
--------------------------------------------
Yes welder series is where I got them. They make it clean and easier for sure
--------------------------------------------
DeepSouthS10 said:
nevermind i think i found them at Welder Series Inc. They are pretty nifty. Certainly makes the idea of building a frame a little less intimidating.
--------------------------------------------
Yes welder series is where I got them. They make it clean and easier for sure
mjavy7
+1y
looking great!
bagged95s10
+1y
Got my little shop steering kit in. And Marcus doin work!
