Drive shaft hits cab

Well i just got my four link welded in, and when i jack up the axel, the drivshaft comes in contact with that cross member, i cut a chunk out, but now it hits the bottom of the cab. Is this a common problem with 17's and should i pull my interior, cut and weld, or get a two stage drivshaft, or get a small diameter driveshaft built. Any suggesttions Thanks a bunch

Don't know if that is normal with 17s, but DO NOT get a 2 peice shaft..it will give you troubles....notch the cab its a lot cheaper

mine hit my cab... sawzall works great now

Hey, how about hitting it with a hammer, that way i don't have to fuck with it much?

just make a tunnel for it

sawzall with take care of it in like 2 mins.

sounds like a good time to begin that bodydrop, huh?

^^ yah that would work EXCELLENT!!!!!

until you tried to drive it....LMAO

(yes i know u were joking)

cut that shit!!!!!

had the same problem in my s10, i tunneled it. it wasn't hard