1991 mazda b2200 3.0v6 swap

If there is only one coil on your engine, you're golden!
You just need a signal from the negative terminal on the coil.

got my drive shaft modified. cost me about 278 but the replaced 2 u-joints and specified grease alemites in the replacement ones. come to find out that a yoke for 2/1/4 inch shaft isnt made anymore they had to match one up in a 2/1/5 and machine it down to fit. its all welded up and ready to go just got to put transmission back together

they also ballanced it as well as painted it up for me. Looks like a factory built shaft

Stoked for you ward!
Now... pictures or it NEVER HAPPENED!
3.0 v6 going to be a loose little truck

What you mean loose? i do have videos of it tho.

Go on youtube and in the search box type in Ward5kustomz and you should see the vids of my mazda

Loose as an adjective:
Not firmly or tightly fixed in place; detached or able to be detached: "a loose tooth".

Slang adjective:
A person/thing that is not predictable or conventional.
You're a "loose unit" Ward
You're truck will be loooooooooooose!
Get loose.

Maybe it's just a down under thing

Btw, LOVE the accent!

finally got my driveshaft today

got the frame mounts moved in 3/8 inch. engine sits in much better. got the wire harness inplace just got to finish the fuel system

what a day! i got the engine and trans in place and ready to go. All i have left to do is the plumbing on the fuel system few more electrical issues. just got to figure out what radiator will fit in place of the factory mazda radiator. next thing is to shorten the driveshaft and build a crossmember for the transmission. but other than that its about ready to go.