Smoothing engine?

2523 views
26 replies
18 following
K
Smoothing engine?
blazn avatar
blazn
+1y
I am wanting to smooth and paint my block and other engine components. What is the best way to smooth a block?

thanks
gimp5561 avatar
gimp5561
+1y
lot of sanding with a scotch pad on a air sander
Uncle Fester avatar
Uncle Fester
+1y
And high build promer, a few 30 packs and tons of wet sanding. Looks awesome when done though.
blazn avatar
blazn
+1y
Well I am out of cash for my build so I thought I could work on that!

Fester what are 30 packs?
waynehammer avatar
waynehammer
+1y

post photo
Jance Customs avatar
Jance Customs
+1y
If you're wanting to get the small tight details, I'll sell you a ziplock bag full of dremel sanding bands for $20 shipped.

Sorry for the big pics!



Before

After

Before

After

I used other tools as well, but I used the sanding bands for the all the detail work. It just takes a lot of time...
post photo post photo post photo post photo post photo post photo post photo
Uncle Fester avatar
Uncle Fester
+1y
--------------------------------------------

blazn said:

Well I am out of cash for my build so I thought I could work on that!

Fester what are 30 packs?

--------------------------------------------

Sorry Brad Wayne got it right, going to take loads of patience and beer. Looks like Jance been there. From there its etching primer, high build, wet sanding then paint. Not a easy process but looks hella nice when done.

Good luck.
blazn avatar
blazn
+1y
Well I guess I need to go buy a dremel!!! Luckily, I dont drink so that should save me some extra $$$
stlowburban avatar
stlowburban
+1y
Just a thought but would a flapdisk on a grinder help to do alot of the heavy work and save time if you were easy with it?
Uncle Fester avatar
Uncle Fester
+1y
--------------------------------------------

STLowburban said:

Just a thought but would a flapdisk on a grinder help to do alot of the heavy work and save time if you were easy with it?

--------------------------------------------

Maybe on big open areas but most engines are hard to reach places making a 4 1/2" hard to reach. Maybe a Roloc would help for some but I think Jance has the best bet. Its not easy I just painted mine without sanding and it looks good for general purposes. Takes hard core to make it smooth. Good luck.