Toyota Measurements

i put low profile dust caps on my old yota and they worked out... company called "mr gasket" make em.

hammer works to flatten out dust caps. did that on a few dodges.

17x8" with 38mm offset will be just fine then? im lookin at some enkies off the evos/mitsus.

I have been using these to draw up my chassis, so they may come in handy to others.

Does anyone have the body mount or chassis dimensions for a 98'-04' Tacoma x/cab??

will a 84-88 rear end bolt directly up to a 97 tacoma drive shaft??

4 link axle tabs for a 84-88 rear end, 3inch diameter.....??

2.75" diameter.

cool man, much appreciated!

so if I have a tacoma with a 3in. stockfloor..
a 20x8.5 with a 45mm offset will tuck in the back with no modification to the bedsides?

well i guess a good question would be............ what size tire you gonna run? your thinking about a 20x8.5 my biggest worry would be will it fit in the front without mods. and i guess the answer to that would be no. as far is the rear as long as you run a low pro tire you shouldnt have any issues.