Control Arms?? Who can make some!!!

Damn Seth. Control Arms for everyone!!!

You know it Ben. No one comes through though. Lol. So I'm not really doing too much.

Well, you're gonna have to build two sets for me.

pm sent and serious, let me know

Yea, but thats later on. And those won't fit anythign else. Lol.

Originally posted by jbaker72157



pm sent and serious, let me know

Reply sent, Serious is good.

Originally posted by blazedbowtie82



Like I said, PM me if interested. Just so happens I see this now. Send me a message if you're interested and I'll try to work with you.

And Kyle, I'm not following you.

I think using poly rod ends would be better. but I guess we have a difference in opinion.

You mean like the ones you used on that S10 frame with square arms? I'd like to use those, but not at $50 each. That makes $200 in bushings for upper arms, before the tubing and time. My goal is less than $200 cost for all upper arms, and hopefully lowers too. Shouldnt be anything wrong with a rod end for suspension use.

Originally posted by blazedbowtie82



You mean like the ones you used on that S10 frame with square arms? I'd like to use those, but not at $50 each. That makes $200 in bushings for upper arms, before the tubing and time. My goal is less than $200 cost for all upper arms, and hopefully lowers too. Shouldnt be anything wrong with a rod end for suspension use.I think you meant heims not rod ends. I know a heim is a type of rod end but when I say "rod end" I

Those look good. The only issue I have with them though, is that for adjustament of castor, you can't angle them much. But if I were building arms like that, I'd want the truck there, so I could set the castore where it needs to be and make the arms fit right without adjustment. But thats tough when the truck is so far away. And I know rod ends arent designed for it, but I think they would work alright.