S
In need of switch wiring help...
L
layedout72
+1y
Alright I have a little confusion, and just want to make sure i'm right about this.
8 valves
5 push button switches (front up/down, rear up/down, pancake up only)
5 toggle switch dash panel (front up/down, rear up/down, front corners up/down, pancake up/down)
Basically right now I am drawing a diagram that will let me just follow it instead of guessing at things. I know how to wire the switches and have them work but i'm trying to figure out how to connect both sets of switches safely.
8 valves
5 push button switches (front up/down, rear up/down, pancake up only)
5 toggle switch dash panel (front up/down, rear up/down, front corners up/down, pancake up/down)
Basically right now I am drawing a diagram that will let me just follow it instead of guessing at things. I know how to wire the switches and have them work but i'm trying to figure out how to connect both sets of switches safely.
L
layedout72
+1y
also, what gauge wire would yall reccomend? Is 20 enough?
nigels_world
+1y
Run your 9 wire cable from the valves to the cab and feed it from your switch box and dash switches. Run a diode inline on any wire that you don't want to be energized when the when another switch for that valve is used. 20g is fine.
