Project:******* (CompleteStandstill)-Updated: MAY 3rd, pg9-

u just like cuttin and throwin huh

that looks like a big section of frame...where's the rest of it??

i think i can feel a new frame being built...


hey do you happen to have the piece of the ebrake that the two cables goes into and then mounts onto the rod thing that pulls the brakes? i lost that little bracket thing.

probably somewhere.

Ok, so no news for awhile, been kinda busy, but as of last monday, my frame and every single piece of my rolling chassis(exept the rear axle and steering linkage) is at the fuckin powder coater! I'll have a roller assembled by April 7th for Lay'd Out at the Park in Morristown TN.

Well, frame is back from powder, got everything else back now except a couple nuts and clips and a couple new pieces from the dealer, i'll have it in completed rollin chassis this weekend for Lay'd Out at the Park in Morristown TN. I'll take some detailed pics then.

heres a couple for now tho...

Painted pieces:


Powdercoated gas tank and drain plug, painted sending unit and pump assembly top, stainless hardware in the sender and pump, and a new gasket on the fuel drain.


Powder coated upper and lower Cando Arms, Belltech spindles, Twisted minis motor mounts, stock calipers, misc. brackets.
Painted shocks, stabilizer, steering linkage and steering box.

vey vey vey vey vey nice

Damn son.

Whats th ebillet pieces in the last picture? Wheel spacers?

yep.