PunisheR YotA

well i did a little work on my truck this weekend.
For starters i spend about 4 hrs. on tunning and cleaning it up. the tune-up helped out a lot.
Before my truck was doing good to bark the tires and now.

I've been trying to fig. out where to mount my tach. then i finaly fig. out where.
Here's what all i did to get it done.






Fig. I didn't need to go into to much detail with words and all that.

Must be hard on that engine red lining at a grand everywhere you go.lol jk

looks good man

yea. I got the gears in the trany all back wards and upside down.
Teach me to put a trany together blind folded. GOSH!!!

lol

btw, does any one know where I can get a camper shell for my longbed?
I got a alum. one but it looks real ugly.
I would love to have a nice looking fiderglass one.

try craigslist every once and a while

OK I'm thinking of not doing the basic notch on my yota. I'm thinking of doing a revise notch where the notch is under the rear axle instead of going over top. I'm not worried about big lift just want to go low worth out having a ton of stuff on top. so with all that being said i was looking to see if i could find a detailed drawing of a 86 frame. I can across one and not in in the possess of putting in to AutCAD then converting it to 3dmax. there for when it is done if any one here would like to have access to it i will have it on hand. i fig. with the diagram I got and taking the odd dimensions from my truck it should be for the most part correct.

well it has been some time sence i have updated this.
i havent done a lot to the truck except put air shocks on the back to keep it from bottoming out when i hit bumps.
but as of right now i want to work on the back supention. org. i was wanting to go with a 2 link but now o think a 4 would be more practacil. (if i spelled that right)
so as for a good 4 link not round pipe what are the options.
i dont want round pipe just beacuse it's eazer to weld to square then round.
What i want is 2X2X1/4 sq. tubbing.

for ur notch go with SD notches.. they are nice, and not that much $... as for square link bars im not really sure.. i used round bars.. 2x2 and 1/4 thick ??

ok, i know i have seen how to bag the front of my 86, but i cant find the post.
i know it look simple and the person didn't have to buy much to get it ready for the bags.


any help would be great on locating the post.
also any help on the type and style of bags that would do good.

well, i didn't get it finished but i got close.

I still have to run the air lines, wire, gauges and hook-up everything.
When it's all put to-get-her, <---lol it should lay out in the front after i cut the finder wells.