New Transmember

looks good Seth. Nice work as always.

Yes, they are 4" tall. I am thinking about making one that kicks back down on the exhaust side to work with a 3" tall frame. I could do it for custom orders. Its not much more work. It would require some floor modification above the cross member though I am sure.

Seth, if it unbolts from the actual crossmember, should the bolts not be on the bottom? or is that you can remove the whole bushing plate with the tranny held up by a jack? just wondering.

if the bolts were on the bottom, you might as well keep the stock xmember because they'd hold you up.

You can remove the whole bushing mount with the transmission held up, same as stock. If the bolts where on the bottom it would create extra load on the bolts and threads, and the bolts would be on the ground before the cross member. I designed this so you can install it flat with the bottom of the frame to get the transmission as low as possible.

I am down for one i will pay that for a xmember already fabed

Seth Im selling my Cando Specialties 84-94 tranny crossmember cause at the moment I dont need it & I also want to use the one you make. Im only
going to bag my truck for now & when I stock floor it this winter all that wont really matter. So here is a pic of it & if you know of anybody that needs this type let me know & when its sold Ill get the one you make. Thanks...


CanDo Specialties tranny crossmember-new: $135 shipped to you & no I dont have paypal!!! Sorry guys.

I can build you a stock floor friendly cross member so you can reuse it.

Sounds good to me & in the long run it will save me some cash too!! Now I just need to sell mine & Ill be good to go! Anybody need this part hit me up here or at my other email addy: . Donny

will put this on my list for when i get my yotas titled cleared. hope to have that done this week. should be placing an order through keef for my sheetmetal and grant kustoms for my bag shit, this would be a nice addition as well.