Full Skin Combo Installed!!

OH by the way, that is my fizz can job with the primer!

Just wanted to get it covered with something....





Dev

I found using flat black trim clad really works and is easy to sand off when you are ready to continue

I'll keep that in mind next time!

I just had this primer laying around!



Dev

whats a mini truck without a lil primer?

LOL....Exactly!



Dev

man that looks sharp dev!!!!!

but 1 question. At the bottom does the pan fit flush into the body or do you have to cut that section out of the bed?

It is recommended that you cut out the stock roll pan before installation, but I left mine in and just ended up bending it back a tiny bit!!

I left it for that extra support, may not be much but better than nothing!

And I just had to trim one section out for my plate box! Thats it, not much cutting at all! Only for the braces!


Dev

Looking nice Dev! I'm getting mine soon from FBI! I'm going to fill me tail lights and use LED strips!

I definitely should find some time some day to see this rig in person!

WAIT!!!!

Don't get the one from FBI man! Trust me, that is what I got at first and it sucked!!!

There were quite a few fitment issues!!! And really flimsy metal!!

If you can hold off and save up, go through GrantKustoms!!

You should swing up my way sometime, I am only about an hour and a half away!




Dev
208-610-6814

Sorry man, lol! I've already ordered it! I saved myself about $100 or so because they had a deal going on. One of their techs. Cut out 30 roll pan combos instead of 3! I'm sure I'll be OK on fitment...Not like its been the first time! lol!

I do not plan on using the sheet metal by itself. I'm going to be using 4 square tubing bars to support it!

I know... I should probably listen to you! Lol! But I guess I'm too stubborn, eh?

I'll have to make a day to swing by up there! I will have to wait a little so I can get my dash finished as well as put my interior back together! I've been pretty busy, but I can't resist! Lol!

I'll make sure to save your #!