HELP!!!! tucking 20s

alright heres the deal i have a nice set of 20s from my s10 that tucked very nice on there with a nice 3 inch lip...
i was wondering if anyone can help me in figuring out if they will tuck on here

i dont wanna spend the money to have everything drilled out for 5 lug and then the wheels dont tuck and im fucked i dont no the offset of backspacing on the wheels so wut can i do to test fit any help wud be great

if they are 20 inch with a 3 inch lip i don't think they will tuck,

if you can lay the wheels face down then put a strait edge across the back of the wheel then measure from the strait edge to the mounting face of the wheel and that will tell u the back, also how wide are your wheels?

i wanna say 8.5 or 9 inch wide

sounds like your going to have one hell of a time tucking these

are u running fixed or air ride?

I don't think air ir fixed is gonna make a difference on these 3" lips. Mazda's don't have enough room for deep wheels. Unless you have done some extensive fabrication, you might be better off with a set of front wheel drive offset wheels. Front drivers dont come with big lips like that because of the high offset......very similiar to the mazda's, even tho its RWD.

Well guessing on the info of the wheels you can narrow the frame in the rear then use a s10 rear end, might have to narrow it because Mazda's are a bitch to narrow. But on the front you will prob have to narrow the front frame section just to get them in there. And that means a lot of fab work.