K
ohhh you got JOKES???
p3arlb2200
+1y
lol!
speedster93b
+1y
hahahahahaha
jmzcustomz (jeff)
+1y
A priest, a doctor, and an engineer were waiting one morning for a particularly slow group of golfers.
Engineer: What's with these guys? We must have been waiting for 15 minutes!
Doctor: I don't know but I've never seen such ineptitude!
Priest: Hey, here comes the greenskeeper. Let's have a word with him.
Priest: Hi George. Say George, what's with that group ahead of us? They're rather slow aren't they?
George: Oh yes. That's a group of blind fire fighters. They lost their sight while saving our club house last year. So we let them play here anytime free of charge!
(silence)
Priest: That's so sad. I think I will say a special prayer for them tonight.
Doctor: Good idea. And I'm going to contact my ophthalmologist buddy and see if there's anything he can do for them.
Engineer: Why can't these guys play at night?
Engineer: What's with these guys? We must have been waiting for 15 minutes!
Doctor: I don't know but I've never seen such ineptitude!
Priest: Hey, here comes the greenskeeper. Let's have a word with him.
Priest: Hi George. Say George, what's with that group ahead of us? They're rather slow aren't they?
George: Oh yes. That's a group of blind fire fighters. They lost their sight while saving our club house last year. So we let them play here anytime free of charge!
(silence)
Priest: That's so sad. I think I will say a special prayer for them tonight.
Doctor: Good idea. And I'm going to contact my ophthalmologist buddy and see if there's anything he can do for them.
Engineer: Why can't these guys play at night?
jmzcustomz (jeff)
+1y
Common Tools Explained
To the unitiated, the workshop can be an intimidating place, full of tools you may not know what to do with. To help, here's a helpful explanation of common tools and their uses.
DRILL PRESS:
A tall upright machine useful for suddenly snatching flat metal bar stock out of your hands so that it smacks you in the chest and flings your beer across the room, denting the freshly-painted vertical stabilizer which you had carefully set in the corner where nothing could get to it.
WIRE WHEEL:
Cleans paint off bolts and then throws them somewhere under the workbench with the speed of light . Also removes fingerprints and hard-earned cleco calluses from fingers in about the time it takes you to say, "Oh sh*t!"
ELECTRIC HAND DRILL:
Normally used for spinning pop rivets in their holes until you die of old age.
SKILL SAW:
A portable cutting tool used to make studs too short.
PLIERS:
Used to round off bolt heads. Sometimes used in the creation of blood-blisters.
BELT SANDER:
An electric sanding tool commonly used to convert minor touch-up jobs into major refinishing jobs.
HACKSAW:
One of a family of cutting tools built on the Ouija board principle. It transforms human energy into a crooked, unpredictable motion, and the more you attempt to influence its course, the more dismal your future becomes.
VISE-GRIPS:
Generally used after pliers to completely round off bolt heads. If nothing else is available, they can also be used to transfer intense welding heat to the palm of your hand.
WELDING GLOVES:
Heavy duty leather gloves used to prolong the conduction of intense welding< /SPAN> heat to the palm of your hand.
OXYACETYLENE TORCH:
Used almost entirely for lighting various flammable objects in your shop on fire. Also handy for igniting the grease inside the wheel hub you want the bearing race out of.
TABLE SAW:
A large stationary power tool commonly used to launch wood projectiles for testing wall integrity.
HYDRAULIC FLOOR JACK:
Used for lowering an automobile to the ground after you have installed your new brake shoes, trapping the jack handle firmly under the bum per.
EIGHT-FOOT LONG YELLOW PINE 2X4:
Used for levering an automobile upward off of a trapped hydraulic jack handle.
E-Z OUT BOLT AND STUD EXTRACTOR:
A tool ten times harder than any known drill bit that snaps neatly off in bolt holes thereby ending any possible future use.
BAND SAW:
A large stationary power saw primarily used by most shops to cut good aluminium sheet into smaller pieces that more easily fit into the trash can after you cut on the inside of the line instead of the outside edge.
TWO-TON ENGINE HOIST:
A tool for testing the maximum tensile strength of everything you forgot to disconnect.
CRAFTSMAN 1/2 x 24-INCH SCREWDRIVER:
A very large pry bar that inexplicably has an accurately machined screwdriver tip on the end opposite the handle.
AVIATION METAL SNIPS:
See hacksaw.
PHILLIPS SCREWDRIVER:
Normally used to stab the vacuum seals under lids and for opening old-style paper-and-tin oil cans and splashing oil on your shirt; but can also be used, as the name implies, to strip out Phillips screw heads.
STRAIGHT SCREWDRIVER:
A tool for opening paint cans. Sometimes used to convert common slotted screws into non-removable screws.
PRY BAR:
A tool used to crumple the metal surrounding that clip or bracket you needed to remove in order to replace a 50 cent part.
HOSE CUTTER:
A tool used to make hoses too short.
HAMMER:
Originally employed as a weapon of war, the hammer nowadays is used as a kind of divining rod to locate the most expensive parts adjacent the object we are trying to hit.
MECHANIC'S KNIFE:
Used to open and slice through the contents of cardboard cartons delivered to your front door; works particularly well on contents such as seats, vinyl records, liquids in plastic bottles, collector magazines, refund checks, and rubber or plastic parts. Especially useful for slicing work clothes, but only while in use.
DAMMIT TOOL:
Any handy tool that you grab and throw across the garage while yelling "DAMMIT" at the top of your lungs. It is also, most often, the next tool that you will need.
To the unitiated, the workshop can be an intimidating place, full of tools you may not know what to do with. To help, here's a helpful explanation of common tools and their uses.
DRILL PRESS:
A tall upright machine useful for suddenly snatching flat metal bar stock out of your hands so that it smacks you in the chest and flings your beer across the room, denting the freshly-painted vertical stabilizer which you had carefully set in the corner where nothing could get to it.
WIRE WHEEL:
Cleans paint off bolts and then throws them somewhere under the workbench with the speed of light . Also removes fingerprints and hard-earned cleco calluses from fingers in about the time it takes you to say, "Oh sh*t!"
ELECTRIC HAND DRILL:
Normally used for spinning pop rivets in their holes until you die of old age.
SKILL SAW:
A portable cutting tool used to make studs too short.
PLIERS:
Used to round off bolt heads. Sometimes used in the creation of blood-blisters.
BELT SANDER:
An electric sanding tool commonly used to convert minor touch-up jobs into major refinishing jobs.
HACKSAW:
One of a family of cutting tools built on the Ouija board principle. It transforms human energy into a crooked, unpredictable motion, and the more you attempt to influence its course, the more dismal your future becomes.
VISE-GRIPS:
Generally used after pliers to completely round off bolt heads. If nothing else is available, they can also be used to transfer intense welding heat to the palm of your hand.
WELDING GLOVES:
Heavy duty leather gloves used to prolong the conduction of intense welding< /SPAN> heat to the palm of your hand.
OXYACETYLENE TORCH:
Used almost entirely for lighting various flammable objects in your shop on fire. Also handy for igniting the grease inside the wheel hub you want the bearing race out of.
TABLE SAW:
A large stationary power tool commonly used to launch wood projectiles for testing wall integrity.
HYDRAULIC FLOOR JACK:
Used for lowering an automobile to the ground after you have installed your new brake shoes, trapping the jack handle firmly under the bum per.
EIGHT-FOOT LONG YELLOW PINE 2X4:
Used for levering an automobile upward off of a trapped hydraulic jack handle.
E-Z OUT BOLT AND STUD EXTRACTOR:
A tool ten times harder than any known drill bit that snaps neatly off in bolt holes thereby ending any possible future use.
BAND SAW:
A large stationary power saw primarily used by most shops to cut good aluminium sheet into smaller pieces that more easily fit into the trash can after you cut on the inside of the line instead of the outside edge.
TWO-TON ENGINE HOIST:
A tool for testing the maximum tensile strength of everything you forgot to disconnect.
CRAFTSMAN 1/2 x 24-INCH SCREWDRIVER:
A very large pry bar that inexplicably has an accurately machined screwdriver tip on the end opposite the handle.
AVIATION METAL SNIPS:
See hacksaw.
PHILLIPS SCREWDRIVER:
Normally used to stab the vacuum seals under lids and for opening old-style paper-and-tin oil cans and splashing oil on your shirt; but can also be used, as the name implies, to strip out Phillips screw heads.
STRAIGHT SCREWDRIVER:
A tool for opening paint cans. Sometimes used to convert common slotted screws into non-removable screws.
PRY BAR:
A tool used to crumple the metal surrounding that clip or bracket you needed to remove in order to replace a 50 cent part.
HOSE CUTTER:
A tool used to make hoses too short.
HAMMER:
Originally employed as a weapon of war, the hammer nowadays is used as a kind of divining rod to locate the most expensive parts adjacent the object we are trying to hit.
MECHANIC'S KNIFE:
Used to open and slice through the contents of cardboard cartons delivered to your front door; works particularly well on contents such as seats, vinyl records, liquids in plastic bottles, collector magazines, refund checks, and rubber or plastic parts. Especially useful for slicing work clothes, but only while in use.
DAMMIT TOOL:
Any handy tool that you grab and throw across the garage while yelling "DAMMIT" at the top of your lungs. It is also, most often, the next tool that you will need.
mazdawg(mikey)
+1y
hahahaha i think dammit tool and hammer are my favorites.
devsmazduh
+1y
whats the best thing about 28 year olds?
theres 20 of them.
what do you say to a chick with two black eyes?
nothing, you aready done told her twice.
theres 20 of them.
what do you say to a chick with two black eyes?
nothing, you aready done told her twice.
speedster93b
+1y
Whats the best thing about highschool girls?
The older I get they stay the same age.
The older I get they stay the same age.
jester
+1y
A small boy was lost at a large shopping mall.
He approached a uniformed policeman and said, 'I've lost my grandpa!'
'The cop asked, 'What's he like?'
The little boy hesitated for a moment and then replied,
'Crown Royal whiskey and women with big tits.'
He approached a uniformed policeman and said, 'I've lost my grandpa!'
'The cop asked, 'What's he like?'
The little boy hesitated for a moment and then replied,
'Crown Royal whiskey and women with big tits.'
jester
+1y
AND THEN THE FIGHT STARTED
jester
+1y
The husband store
A store that sells new husbands has opened in New York City, where a woman may go to choose a husband. Among the instructions at the entrance is a description of how the store operates:
You may visit this store ONLY ONCE! There are six floors and the value of the products increase as the shopper ascends the flights. The shopper may choose any item from a particular floor, or may choose to go up to the next floor, but you cannot go back down except to exit the building!
So, a woman goes to the Husband Store to find a husband. On the first floor the sign on the door reads:
Floor 1 - These men Have Jobs. She is intrigued, but continues to the second floor, where the sign reads:
Floor 2 - These men Have Jobs and Love Kids. 'That's nice,' she thinks, 'but I want more.' So she continues upward. The third floor sign reads:
Floor 3 - These men Have Jobs, Love Kids, and are Extremely Good Looking. 'Wow,' she thinks, but feels compelled to keep going. She goes to the fourth floor and the sign reads:
Floor 4 - These men Have Jobs, Love Kids, are Drop-dead Good Looking and Help with Housework. 'Oh, mercy me!' she exclaims, 'I can hardly stand it!' Still, she goes to the fifth floor and the sign reads:
Floor 5 - These men Have Jobs, Love Kids, are Drop-dead Gorgeous, Help with Housework, and Have a Strong Romantic Streak. She is so tempted to stay, but she goes to the sixth floor, where the sign reads:
Floor 6 - You are visitor 31,456,012 to this floor. There are no men on this floor. This floor exists solely as proof that women are impossible to please. Thank you for shopping at the Husband Store.
PLEASE NOTE:
To avoid gender bias charges, the store's owner opened a New Wives store just across the street.
The first floor has wives that love sex.
The second floor has wives that love sex and have money and like beer.
The third, fourth, fifth and sixth floors have never been visited.
A store that sells new husbands has opened in New York City, where a woman may go to choose a husband. Among the instructions at the entrance is a description of how the store operates:
You may visit this store ONLY ONCE! There are six floors and the value of the products increase as the shopper ascends the flights. The shopper may choose any item from a particular floor, or may choose to go up to the next floor, but you cannot go back down except to exit the building!
So, a woman goes to the Husband Store to find a husband. On the first floor the sign on the door reads:
Floor 1 - These men Have Jobs. She is intrigued, but continues to the second floor, where the sign reads:
Floor 2 - These men Have Jobs and Love Kids. 'That's nice,' she thinks, 'but I want more.' So she continues upward. The third floor sign reads:
Floor 3 - These men Have Jobs, Love Kids, and are Extremely Good Looking. 'Wow,' she thinks, but feels compelled to keep going. She goes to the fourth floor and the sign reads:
Floor 4 - These men Have Jobs, Love Kids, are Drop-dead Good Looking and Help with Housework. 'Oh, mercy me!' she exclaims, 'I can hardly stand it!' Still, she goes to the fifth floor and the sign reads:
Floor 5 - These men Have Jobs, Love Kids, are Drop-dead Gorgeous, Help with Housework, and Have a Strong Romantic Streak. She is so tempted to stay, but she goes to the sixth floor, where the sign reads:
Floor 6 - You are visitor 31,456,012 to this floor. There are no men on this floor. This floor exists solely as proof that women are impossible to please. Thank you for shopping at the Husband Store.
PLEASE NOTE:
To avoid gender bias charges, the store's owner opened a New Wives store just across the street.
The first floor has wives that love sex.
The second floor has wives that love sex and have money and like beer.
The third, fourth, fifth and sixth floors have never been visited.