help me out small block and bags/hydraulics

Typically the ram is mounted to the top of the axel. I wanted something a little more compact - my rams are mounted outside the frame witht the lower mount being a heim joint connected approximately where the lower shock mount would be.

Again, typically most run a mini-coil and the leaf springs. I wanted a better ride so I am running a forward 4 link setup.

Usually 6" rams up front and 8-12" in the rear.

2 pump setups are designed to raise either the front or the rear. 4 dump setups allow lowering each corner individually. A 3 pump setup can either have 1 front and 2 rear pumps for crazy 3 wheel or 2 front and 1 rear for hopping. My setup has 4 pumps and 4 dumps.

that's what i was thinking about the pumps/dumps. thanks.

i would have to say that they have both have their ups and their downs (pun intended) if u decide to go hydros check out layitlow.com they have a section with people dedidacated to them .... but personally i would i would got with hydros cuz i grew up with them (i even juiced my bike ) and i been in cars were u could never tell they had them ... if its installed right it should be as smooth of a ride as with bags just my .02

If ya do go to layitlow.com, avoid the Altered-Images thread - those guys got no clue