i hate these posts..... london, ontario :)

Welcome to the scene. It does not look like you have too bad of a start. Especially if it runs. LOL

thanks for the welcomes

plans for now are drop, new shocks for front, yota front bumper (checking on a source this weekend for one locally) and waiting for a certain someone to make rollpans

oh, and wheels.. but if i get wheels they gotta be cheap. super cheap. hahaha...
i want garbage can lid rims

Welcome to the site and if you need anything just pm me I have a complete extra cab out back that is getting parted out 4x4 box and fenders and i even have a extra b2600i hood.

you got a center console

Welcome Home.

i guess i forgot to post this pic.

last weekend i pulled off the bumper and grille, smashed the back of the bumper with the butt end of an axe to help somewhat straighten it out, and painted the both with a can of flat black i had lying around, at least until i can replace the 2 of them.. since the grille is cracked and the bumper...... well it looks like that ---^ haha

i also sprayed some rockerguard in behind

and i used a heat gun to remove the "MAZDA" logo and the mazda east dealership logo off the tailgate.. also started on the side trim on the box but didn't get far :p



yesterday i did an oil change, phew it needed it... and i'll be flushing transmission fluid maybe today or tomorrow

and hopefully visiting mike tomorrow for a couple things

also found out there might be a wiring issue.. there was a couple interior lights along with passenger rear signal light that weren't working.. but now they are.... neither reverse light is working but that may just be the bulbs.... heh

still haven't gotten it lowered.. this weekend and next are super busy so i wouldn't have time to get the alignment after... arg!

I wish I did I would be sending it to slammedyota. I am still trying to find him one that is in mint condition or at least really close. I am starting to build custom ones soon so I will take pics and see if you guys like.

If you need drop blocks,I have 2 and 3" blocks, and I also have 2 good grilles, one stock 2wd like yours, and a 4x4. I have also stock tail light lenses that have been redded-out and a sliding rear window if you're interested in any of that stuff.

I'm about 2 and a half hours from London though.

welcome to the scene

ah update... saw mike on the weekend.
got pathfinder wheels, 15x6, just gotta clean them up a little and they'll be summer wheels for now
also got a bedliner and a couple small pieces.

thanks a ton!

also last weekend picked up an extang tonneau for $100... the width is a bit short but i'll follow mike's lead with his and just bend the brackets a bit to hold under the lip proper.

i've posted in another thread i'm having a surging issue, will be checking a few things this weekend hopefully, and pray it's not the carb and an easier fix than that

also did a quick sig from the few limited pics i got.. lol

i'm laid off in jan/feb so might be using a friends garage to attempt the lowering since i already have the 3" blocks. i liked how mike's beater sits, so i'll likely remove a leaf also and crank down the torsions.

this weekend i'm going to remove the rear bumper also i don't much care about the notches in the rear, and don't feel like welding a rollpan on it.. i'll save that for another truck later in better condition :p lol.

and i've used the truck to carry a snowblower now just need to get it running too... arg!