Street Source is shutting down April 30th, 2026. Read the announcement
brake booster and master cylinder
2037 views
11 replies
2 following
K
brake booster and master cylinder
Cusser
+1y
"how do you adjust the push rod ?"
I used a bent needle-nosed Vise-Grips and a wrench. If the new MC was 2 mm deeper than the existing one, I loosened the lock nut and turned the pushrod to lengthen it 2 mm, then tightened the locknut.
I used a bent needle-nosed Vise-Grips and a wrench. If the new MC was 2 mm deeper than the existing one, I loosened the lock nut and turned the pushrod to lengthen it 2 mm, then tightened the locknut.
Related Discussions in Mazda Engine Swaps
Thread
Posts
Last Post
50
H
last post by
Harleylover61 +1y
