Lets try this again, My Mazda B2000 project.

damn truck looks so good!   i heard you are my new neighbor?!

MORE!!!  

filled in the gap from the roll pan to the bed...cut a hole for access to the hydraulics, now I just need to figure out how to hinge it, and its off to paint!!

Did you have all the chrome accents replated?  They look flawless in the pics

Yeah, $400 later. It was a whole ordeal. If you look back to the beginning, the truck is painted white. Well it was black from the factory, so overspray was everywhere. I have had to replace all the rubber stops, seals, shims, everything had overspray on it from the terrible previous paint job. I took the stainless trim into the chrome shop to have them straightened, stripped and rechromed. Well... they didn't do such a great job. They taped off the rubber trim and left all the sweet white overspray on the rubber. So I had to remove all the rubber from the trim. No big deal, except the rubber is what keeps the trim around the a-pillar and above the window (drip rail)on the truck. So that piece is now glued to the drip rail.   Thanks for noticing though, at least someone did.

AND MORE!!!!  

Bed went on for a final test fit...I got the hole in the right spot...

truck is sick as ..... i did not have good luck with tabs on the front lower arm they bent all to hell went with the uni balls works ahell of alot better and thay are only $35.00 each just a thought tuck is as .... now go drag that shit

Sick truck im lovin it, what are those headlights from i have always liked that look?

hydroyota... I am not sure what tabs on the lower arm you are talking about. The only tabs on the lower arm are the tabs for the heim joint at the end of the cylinder.   Doored... the headlights are from a 01-06 ford ranger

on the install of the headlights, how much of the grill did you have to trim and what is your plan for a fuel tank /cell

I believe it is staying in the stock location.