K
95 Sierra Re-do
laidoutcourier
+1y
looks bad ass
tre5
+1y
nice!
Gonzalez Kustomz Fab Shop
+1y
Great work !
i8nt2lo
+1y
Thanks fellas!
bagged95s10
+1y
Looks good! Like what ya did with the air lines. You should make some covers for the cups so ya don't c any hose
bdydrppup
+1y
Very nice
bdydrp18
+1y
Did you lengthen the wiring harness between the valve block and the computer??
i8nt2lo
+1y
Computer? Not sure what you're askin' here. Only wire I had to extend was for the switch box from the valve manifold to the switch speed module. Not sure if that's what you were talkin' about or not.
bdydrp18
+1y
Yeah sorry that's what I meant. Figured that's is what you did because that harness is only like a foot long. I was going to do that with mine but I didn't know if it would screw with that controller.
i8nt2lo
+1y
I had some 9-wire layin' around so I just matched the colors up and soldered it together. All it does is lengthen it. You could just use separate wires individually if you wanted (think it's 8). You're right about them being so short, only downfall in my opinion. I did it on a dually too, but it was using an AVS switch box. Worked perfectly.