drag blocks?

2161 views
17 replies
9 following
K
drag blocks?
low95xlt avatar
low95xlt
+1y
u got that off fsc didn't u i was looking at that u stole my ti bar u bastard LOL... at least put up some good videos of it ok
kicker1_solo avatar
kicker1_solo
+1y
It's cool, you don't have to cut your truck up if you don't want to puss.


I did though
jcampbell1180 avatar
jcampbell1180
+1y


Actually, it's not a truck...it's a Malibu.

...and a pretty bitchin' one at that. I don't think I'd wanna cut it up too bad, either. Or drag it, blocks or otherwise, for that matter. Just seems like it's pretty hard on the vehicle in general.



dragnasty avatar
dragnasty
+1y
No Comment.....
low95xlt avatar
low95xlt
+1y
dude u know how bad arse that would be laid out hmmm wanna sell it LOL n i iwll lay it out for ya
jcampbell1180 avatar
jcampbell1180
+1y


A no comment from you speaks volumes.

You drag-fags are all the same.
kicker1_solo avatar
kicker1_solo
+1y
oh, it's that one.... yeah, very sweet
illegal regalã¢â€žâ¢ avatar
illegal regalã¢â€žâ¢
+1y
yea cuttin up a truck is no problem for me.. they're everywhere but these malibu's are gettin kinda scarce in nice unrotted shape and startin to get more and more pricier every year.

to lay it out-
I did some searchin and think a drop spindle and s10 drop a-arm for bags will do it with the frame notch for the tie rods. Anybody got some used lowers for cheap???

In the rear I'm thinkin just different cups or maybe a behind the axle bracket setup with c-notch, possible mini-tub and notch the body in front of the housing for driveshaft clearence. Might be too much cuttin for the car goin that route.