Baggin a Colorado

For the front, are ya'll using drop control arms, drop balljoints or what to bag?

I used djm control arms and modified uppers. The djm arms are not nessecary, but I think it looks a little better, and you wont have to notch your frame for them

Thanks. That helps. I'm considering just gettin some lowers now so I can drive with it lowered even more then the zq8 package until I get the shit to bag.

yeah, they are some decent arms, with those arms and 3" blocks out back, you will scrape that big ass tranny crossmember everywhere

Clean Cut Creations has a tranny X-member kit that will do you alot of good.www.cleancutcreations.com

I used the 2" drop balljoints on mine with the factory arms

Originally posted by ghettoTB



Is the Colorado and Trailblazer suspensions the same in the front?

absolutely not

thanks alot..

Originally posted by gtcuztom



Edited: 11/27/2006 6:51:07 PM by gtcuztom

Edited: 11/19/2006 7:07:10 PM by gtcuztom

GTC Fabrication is coming out with a badass rear kit for the Canyon/Colorado. Keep checking their website, it will be up there within the next 30 days.

Thank You Garrit Hunt GTC Fabrication www.GTCfabrication.comgtcfabrication@hotmail.com Phone:208-407-2704 Fax: 1-866-420-0766

www.gtcfabrication.com208-853-1332

When will your page be up? I would love to have it bagged soon. And want to see what u can provide.

Well, I'm probably not the person you want to ask on what it takes to bag one, being that mine started at the off-road pkg level. I had to shorten my rearend a total of 4 1/2 inches in the back, rebuild all 4 crossmembers, rebuild the whole frontend, fuel cell is a must and in the four door, if you want to keep a one piece driveshaft, you have to rebuild transmission tunnel from the centerconsule back. ALOT of work, but damn they look good layin. Especially the crew cabs.