Square tube control arms

those look badass

what type of tubing is that? looks good.

where are the bags goin?

Originally posted by laynwindows



where are the bags goin?

ya, i dont see much room for them either

looks badass

damn, those look awesome!

Could those be the most original control arms out there right now??? I have to say, Im proud to have assisted my fellow club member (Mr. Jake Boeger) in such a milestone in fabrication. keep it up!

Square tubing, square chassis...AWSOME! combonation...Here's to you my man

I'm actually planning on doing something similar for my truck. I think square tubing would look better considering the frame is square. Did you cut the tubing to bend and then weld it? Or are you using some bender for them?

Edited: 4/16/2006 1:38:56 PM by stockflooredsdime

Thanks for all the compliments!!

-----------------------------------

Yes, there isn't much room for a 2500 pound bag between the arms. I am either going to use a smaller bag (if I can find one) or mount the bag somewhere else.

-------------------------------

I am using a hand tubing bender (90 degree die with an 8 ton bottle jack) for the arms, thanks to Kyle Parscal. The frame was mandrel bent.