88-98 to lay on 255\35\20 in front

Edited: 8/21/2005 8:30:03 PM by deflaytedwayz2

Edited: 8/21/2005 8:29:32 PM by deflaytedwayz2

thanks for all the help guys... found out that im not good at math.. haha and it does lay i got mixed up with my numbers. but it does lay hard, with 3's and 2's my customer was quite pleased

I am haveing the same probs, so for mine i have to cut my fromt frame to make the tie rods go up and i know i have to lose the inter fenders, aslo what easle do i have to cut or do, aslo i am going to rase my exhaust. i have drop 2 inch spindles. so let me know too and aslo any one have any pics of this project??

when you guys are raising the crossover pipe, doesnt it get pretty darn close to the oilpan??

I drug off my original y-pipe, and got a raised one. That raised one was 1/8" from the oilpan/flywheel, and I somehow managed to drag through it too. It actually pushed up into my flywheel shround, pushing the shroud into my flywheel, so I knew I needed a new route. It is now run straight back, over the tranny crossmember, and crosses over under the driveshaft. At its lowest point, it is 1" from the ground.

Kyle? I dont suppose you got pictures of that do ya? I gotta do that to mine I think..