threads
Page 6 of 12
Toyota Pickup Projects \  Rebuild Project - Updated 6-28-10

Rebuild Project - Updated 6-28-10

Toyota Pickup Projects
views 12435
replies 114
following 24
 
smctoy   +1y
looking good...are u going to have the frame at scr8fest??
baha   +1y
Thanks Andrew

Thanks Obey, maybe I could have a YotaScene barbeque and get all the GA boys together for when I need to put the cab back on!

Bump your truck came out good what don't you like about it?

SMCToy Yeah I should have it there Donny, I hope for it to be a full rolling chassis by then but I'm always faster at doing work in my mind then real life
layedout72   +1y
Pinch was cut so short it doesn't lay, when in reality, it should have layed rocker in the first place. thats fine though, nothing a nice solid sheet metal floor cant take care of later down the road. not happy at all with how the exhaust HAS to be ran, but again, it can be done with more money than I should spend on exhaust. Just little shit I shouldn't have to do once I got the truck back. oh well...live and learn huh.

oh and i really need a different way to route wires and all that nonsense. hardlines will solve that though. I really want stainless everything. brake lines, fuel lines, air lines, and possibly run some to hide all my compressor wiring and valve wiring to the back. I want it to be sooo fucking clean, and this part is of course my job and not the builders.

oh and rob, what shows are you hoping to make in the 2010 season a little farther west of you? stc, pandamonium, allstar, slammin? i'd love to see this thing in person when it's done.
baha   +1y
How much do you have left before it lays? I'm making sure the frame will lay flat on the ground but I don't really care about laying flat rocker I'll probably put some kind of plate on the frame to protect the paint on the underside of the body.

Wow thanks Bump I hope to have it at Scrapin The Coast next year! Besides that I'll definitely be at Slammin & Jammin, and All Star, are you going to All Start this year?

Well getting close to being able to move on to the suspension.

Got the frame flipped back over so I can install the new notches!



Old notch I'm replacing, this notch is 4" taller than the new one so I should be able to keep the bed floor lower.


Made new notches made out of 2x4 11 gauge


No turning back now


I hope to have the new notches installed tomorrow, and maybe the new notch cross member, anyone have any ideas? I want to do something simple and clean not to crazy.
baha   +1y
New Notches are in!


New Cross member is in also just have to finish passenger side.




Starting to look a lot better now, next I'll need to replace the inner frame rail with flat plate to match the notch since the notch isn't as wide.
xtotalanarcoix   +1y
2x4 notches look so much better than those 8 piece weld together crap, but I think most of us learned this the hard way hahahaha. Looks good, keep truckin'
90-b22dawg [andrew]   +1y
notches look tons better now... keep up the good work...
layedout72   +1y
looks very good rob.
shaggy_tacoman   +1y
nice work
lowyota95   +1y
LOOKING GOOD BAHA! I LIKE THE NOTCH, KINDA WISH I HAD GONE THAT DIRECTION WITH MINE...