driveline grinding noise. HELP!!!!

OMG! i will take my axle off and redo the rear end so its not so tight before i spend that kind of money!
thanks for the heads up tho man!

you can get a slip yoke installed into the drive shaft to relieve the motion during suspension cycle. theres a member on here that installed one. cant remember his id but its in the build threads. maybe someone will read this and remember who it is and post that for you

find a local driveline shop and just bring in your driveshaft.

I think that price is for a new driveshaft

for a whole new drive shaft thats not too bad

hopefully i will get the driveshaft out tomorrow and get it into a driveline shop. i will keep you guys posted

go to a junk yard, get an excab ranger driveshaft. get the driveshaft shop to cut the end off the mazda and off the ranger shafts and weld the mazda one back on the ranger one. there excab ranger driveshaft is a slip shaft. hope this helps you.

so is the drive shift out of a 4x4 mazda, and you may not have to swap out one side

what? its the stock driveshaft......not sure what your getting at here...?

the raer shaft in a 4x4 mazda is a slip shaft as well, and you may not have to swap out the rear yock