blown head gasket

I just found out my truck has a blown head gasket today. I plan on pulling the motor and doing a small rebuild. Does anyone have any suggestions on any up grades while I'm in there? I already have a webber and a header that is currently installed. It is an 89 2.2 bty.

Main bearings/oil pump/rod bearings/gasket kitt full top to bottom/ water pump resurface head. and block to make sure you have a clean mateing surface... goodluck!... let me ... kno..

if your pullin the engine, and your truck is standard, may be a good idea to swap out the clutch, and resurface the flywheel. (unless it was just done obviously)

Also you should change the timing belt.