need to go a little lower

So i am sixteen and need a little advise...

i put three inch blocks in the back and took out a middle leaf. but i want to go like an inch lower.

would it be bad to take out the overload or another leaf??

if so how can i get the back lower other than bagging it??

well only leave your main and overload leaf .with the block

that should almost put you frame to axle..

remove or cut bumpstops.. rear and remove the fronts.

if it goes to low you may have to cut the nump stop braacket so it doesnt bang metal to metal

(all this comin from me a 15yr old) haha but yea thats how it goes

um...go to a 4 inch block?

um...go to a 4 inch block instead

he said he took out A middle leaf .. so only 1 he removed ..

so if he was to remove the other middle one he should be good

take out all the springs except the main and the overload(small stubby on the bottom of the pack)
put the overload on the very bottom!!!!!!

cut you rear bumps top in half(the rubber thingy ontop of the rear end held down by ubolts)

you should be good i would invest in some air shocks for the back better ride and semi adjustable

yes SIR!!

accept i completely removed my bympstops

Thanks alot guys. im gonna take out the other leaf and see where that gets me. i have another question though.

i have turned the torsion bolt ten complete turns. should i go more than that?? or should i just flip the ball joints?

you can go more but you need to re-index them . .

there is a write up if you dont know how !