FBI shock relocator kit

So I recieved some more parts for the baggin' setup!

Got my notches, 4-link, and my shock relocation kit.

4-link was smaller than I thought! And the heim joints are crazy!

Lol, the point of this thread is:

I ordered 2 relocation kits for the shocks. Does one kit do both sides or just one?

Cause if it does'nt this kit is confusing! lol!

Anyone know how to put it together?

Nobody, eh?

lol one kit does left and right side

the long pieces go on the axle, and the tab pieces go on the frame, typically the notch. unless they have a rounded edge on them then you have to make a tubluar crossmember for them to mount, i hope i helped.

Crap, lol. Now I gotta try and sell it...

did i help?

Wait a second. lol... now that I re-read it, it seems your talking about the rear shocks. I'm talking about the front kit they have.

And now that I took another look at it, the front still uses one kit for both sides.

So I still need to sell a kit, lol!

Although, my only question is what the holes are on the brackets...

holes are there for the bolts (on bottom) the upper mounts should have a hole on the top of them so the shocks stud will go through it.

...like going out and buying bolts to mount the upper bracket?

The lower shock mount is supposed to be welded to the LCA according to FBI. Maybe you can drill a hole in the LCA to mount it too?

weld it both lower and upper mounts should be welded, refer to v8mazda's build on cids truck he has pics of it