Stockfloorin my 2000 crew cab on 22's..

Nice! Subscribing to this!

Those are some tough looking arms for sure!!

i think there eazier to produce too if you have a cnc plasmacutter , i still think the ones build out of pipe would be stronger and more lightweight

ok i must be blind but the only spot i see where you might have "z" the frame is where ya cut the old bent frame off, is the where its z-ed ?

hey did u cut font to back on the floor for the tranny and carrier bearing.....?

i cut the front first. but only had to do the front. the back barely cleared.

oh and on the shocks. next time im workin on it ill get the info off the shocks for ya.

heres my upper balljoint cover..

BOOOOOOMMMM!!!!! so sick man....I dnt hear much outa talks club anymore always have some sick stuff

so i assume you cut to the main support between the front and the back leaving the strength in the original floor?