Tre5 Customs Body dropping a NBS Chevy

haha nice comeback chad! ill give u that one lol. but trucks lookin pretty snazzy! lol

:WHIP: back to work

Tomorrow. I worked on it a little last week, but I had some other stuff to do and I was waiting on a new gas tank.

Some more work. The frame is now free and clear of the "table"The rear had to go straight down to clear the back of the cab...The front...

Looks great Jeremy! You are skipping right thru it...

comin out awesome!! cant wait to see it done!

I'll hopefully have some pictures at the end of the day today. Trying to get the frame ready for the body to go back on by the weekend.

Some more random shots. The exhaust is done. I had to lean the cats back at the motor and start new after the cats. The trans cross member is also done. It is bolted in on the sides and has a notch for the exhaust. The new gas tank (made by Mouse) is also installed. I had to make a new forward mount, but I was able to use the rearward mount because that part of the frame was still intact. The ABS module is mounted in the factory spot, just two tabs off the top edge of the new frame. The charcoal canister is turned on it's side and mounted in the same area as the factory had it. I just turned it on it's side so there will not be a clearance issue with the cab floor. Lastly, I installed a new cross member that the new Toyota carrier bearing will mount to. I should have the drive shaft back tomorrow. As soon as I get the mount done for that and the rest of the wires and lines ran it will go back under the cab. That will happen by Monday.

great build!!