86 Crew cab C10 "full frame build"
26968 views
168 replies
77 following
K
86 Crew cab C10 "full frame build"
bagged08
+1y
So fucking sic. Rearend is pure uncut dope.
mjavy7
+1y
WOW! I can't wait to see more!
oxsign
+1y
OK I'm in..............
dragndime
+1y
What part of SC are you from?
snoopy1750
+1y
--------------------------------------------
dragndime said:
What part of SC are you from?
--------------------------------------------
Charleston
dragndime said:
What part of SC are you from?
--------------------------------------------
Charleston
dragndime
+1y
Damn, I'm from Charleston too. I'll be moving back in a couple of months when I get out of the Marine Corps.
snoopy1750
+1y
Here are some pictures of the truck at ride height. The long bed was cut down for mock up and will be replaced with a short bed when it gets home. The bed was also moved closer to the cab to tighten the gap up. I'm going to also tighten the door gaps and hood gap.
patlalande123
+1y
i know it would have been hard, but you definitely should have kept it a long bed!
this build is absolutely ... i want to type too many words to finish the sentence.
you sir do know how to open your pocket up for your vehicles.
you build hot rods, whats your personal prize possession.. I'm hoping a rad camaro, but I'm sure i will be happy with anything you show..
this build is absolutely ... i want to type too many words to finish the sentence.
you sir do know how to open your pocket up for your vehicles.
you build hot rods, whats your personal prize possession.. I'm hoping a rad camaro, but I'm sure i will be happy with anything you show..
DeepSouthS10
+1y
there is so much awesome here i can hardly form words for what i'm feeling....
snoopy1750
+1y
Edited: 3/21/2012 8:16:16 PM by snoopy1750
Well since I don't have the C-10 home yet and I need something to work on here's the next project. I will be cutting up my daily to lay frame and it's getting a face lift. I have all the parts to convert the sheet metal over to 2012.
Well since I don't have the C-10 home yet and I need something to work on here's the next project. I will be cutting up my daily to lay frame and it's getting a face lift. I have all the parts to convert the sheet metal over to 2012.
