project whiskey tango -- sfbd f150

thankx for the info on the 2 piece shaft. i dont know how to post pix, but u can look on my myspace page its the silver ford with the black rims, the same guy had the blue and white standard cab it was an inch into the doors you will probably see it in my pix......myspace.com/ericlaydsonoma@yahoo.com ............i dont blame you for wearing flip flops but you gotta becareful not to get any hott slag between the toes!!!!!

eric: i tried to look at your page, but the link doesnt work.

I started building my frame finally. Im using 2x4 and the factory front clip. I also cut the rest of the bottom of factory bed floor out for bd...going to make all new mounts.

yea I remember that stage more than a couple of times now good looking build keep it going

Edited: 3/13/2011 4:21:17 PM by david lee

I got my 07 navi dash in, sides bolted in, but had to modify all the other metal in dash....When its all done, im going red with interior(so dont mind the tan on charcoal) all comments welcome.



got a rear axle and spindles out of a police intercepter, already 3 inches narrower, and more common bolt pattern. Im not sure why the brakes are opposite of each other on the rotors, but im sure theres a purpose.

we got our lift up finally...should help out



box full of tabs n gussetts froom Guilty by design



rear frame rails and crossmember





got cab on wheels so i can move it around easier



getting my weld on

i like this truck!!!!

Edited: 5/11/2011 11:50:53 AM by david lee

Edited: 5/11/2011 11:48:15 AM by david lee

Got the frame mostly together now...





Drove to atl and got a killer deal on these 24s off the 'ol craigslist monday night.



Def gotta build or buy some new control arms, ball joints are maxed out now



24x10 ferretti bellagios on one month old 305/35/24

my buddy gave me this old controller, and i rewired it between cars at work to use as my new switchbox

Nice man, I have a buddy of mine wiring my original nintendo to be used to turn my golf cart on and for the switches! The frame is looking good man!

thanks, Im excited to use the controller.

heres my progress so far..





weldings so much easier this way

been a while since i did an update. Ive got body mounts done for cab, and firewall cut out for 305/35/24s, and cut the back of the rocker so it would lay flat about an inch lower. Next up im narrowing the rear end and getting all the tabs handled for it.