Anyone know?

I need to know how far apart vertically the upper and lower control arms are mounted at the frame on a Pre-Tacoma.  I've looked at all the blueprints and stuff i could find but they don't show this.  Center of the upper shaft to center of the bolt on the lowers.  Thanks.

Come on Seth, I''m counting on ya. LOL

< holding arms out > its about yay wide

Boooghar I thought of that but your arms are longer than mine. 

well fine then, use this instead

if you need it bigger, i can email it over to you, lemmie know

Boooghar I really appreciate it but I've seen that and it doesn't have control arm mounts since it's a fwd frame and those were straight axle.  There's a 2wd drive diagram in the Toyota section but it doesn't have that spec. Your a good dude to find that for me though. 

Boooghar where did you find that? i would love to have one for the 2wd extra and standard cab. if at all possible  

Dick2  in the stickies for the Toyota section there's one for an 85 2wd in the first post.

i found it on a rock crawling forum