manual valves...lets see em.

thanks for the comments guys, i take it there arent alot of them out there.

yea soldered joints can hold more than sufficient psi for bagged vehicles. its when heat and chemicals are induced that soldered joints should be switched to brazed. theres a guy running around here with push connect fittings on his truck. ill try to get some pics for you guys.

---------------------------------------------Originally posted by OldSkool720thanks for the comments guys, i take it there arent alot of them out there.---------------------------------------------I think you're right but I wouldn't be surprised to see a few more pop up after that badass picture of yours bro. Nicely done.

lets see some more!!!

very cool

Very nicely done. I have never seen such an elaborate setup. Keep up the good work! I have two ?'s... 1. Could you have turned the vale vertically so the handle could point upwards?2. What do you have Front, Back & 4 corners?

Yeah the valve handles can be turned vertical or anywhich way. The front 3 are down and the back 3 up and the back is t'd off, it also helps being a plumber lol also sweat fittings can hold well into the 200 psi.

Looks like a trombone...I love it I remember rocking my manual valves back in the day, I loved em.

anybody still rockin the manuel pnuematic valves?? had em when i was in high school lol air comes right out of the switch lol! that setup looks badass

had same set up back in the day but mine looked like shit lol