99 Dime SFBD on 22s Canti setup,custom bed(project buttraped)..updated 10/27/2010

---------------------------------------------Originally posted by maniacalminiit has a parallel 4-link with a watts link, how is that not obvious. i give the kutthroats guy props for ignoring the hecklers. looks good, i like it. ---------------------------------------------it doesnt matte rif it had a 48 link with 4 pan hard bars and 7 watts links the way the lift bars are set up its gonna have the side to side movement of a 2 link now if the lift bars were seperat like they should be then it will be able to articulate like a 4 link should

 Truck took 1st underconstruction trucks at scrapin the smokies this past weekend which was cool,hoping to have it back out for scr8pfest in septemeber we will see 

truck was sicnice to meet you guys finally

looks really bad ass! just not to sure about having those lift bars connected.....?

The fab work looks top notch.  Nice welds and nice flow. The bag mounts need to be solid mount.  You cannot have pivots on the ends of a bag like that.  It will cause the bag to push sidways when you air it up.It seems like the canti is equal length.  Seems like alot of work to make all those links just to get the same lift and ride as if you just put the bag on the axel. Any good fabricator will understand other peoples opinions and take there recomendations into consideration. 

thanks guys for all the comments/opinions, and thanks to trevor at the shop for keeping the thread alive... and a lil note to, the truck is no where of being finish, changes can be made at anytime and prolly will. once again thanks, and im all ears to ideas if interested and maybe take some into consideration.

hoping to have this BUcket rolling for scr8pfest

48 link with 4 pan hard bars and 7 watts links. Haha.