OEM Terror...Our '09 SEMA project

We've gone from this:  To this:   Check out an upcoming issue of Stree Trucks Magazine for the full tech article of why we did what and what we used to do it.  Should be out in a couple months and is really in dept on the front end of this thing. 

 One side of the front tubbed.  It doesn't look like much but it was actually quite a bit of room needed.  Just came out like factory.  Max did this one: 

This thing is lookin killer, A LOT of creativity guys.  KEEP up the awesome work and keep us posted!

I used my last post of the month to say this thing is fucking sick!

So sick

that thing is SICK!!!! Excuse me while i pick my mouth up off the floor!

that thing is SICK!!!! Excuse me while i pick my mouth up off the floor!

This is one bad ass ride.

Got the rear stuff back from powdercoat: 

Built the fuel cell using all of the oem sensors and valves.  We machined pieces out of aluminum to house the rollover valve and other pieces.  We also machined a piece to hold the fuel pump quite flush to the top keeping everything snug to the floor.