Two toning with a single stage acrylic enamel over bc/cc?

I understand the correct way would be to lay down my two tone, and then reclear the entire car. But this is a daily, and I don't want to invest that much in it, and I'm learning
 
I figure that if I ran a single stage, it would cut down on costs, time, effort, and a bigger line that would be created doing it with the base/clear.
This would be a solid color, no metallic.

Is there a question to be answered ? This sounds like a statement, rather than a question.

Ha ha. Can I do it an expect decent results? Or is it going to be a total disaster?

And there is a question mark in the title!

itll be fine, BUT i would choose a urethane single stage. plus your gona have a hell of a tape line.

dont do it. save up for bc/cc material or dont bother. i wouldnt cross a an arcylic enamel with a urethane.  the enamel will not hold up as long too.