cavalier intake manifold on s10

marks truck, Im not sure what year it was off of cuz a friend had it lying around.. we used a v6 throttle cable. bolted right in but had to adapt the linkage end on the throttle body to tighten the slack

I dug through all that BS on s10 forums and found the part number: 3AE PA66 GF33. That's what the guy says will work.

i went to the junk yard, u pull and pay.. found a 2000 cavi pulled off the intake manifold and snagged the throttle cable while i was at it.. $65 was all it cost me.. it clears my UCA by like and inch, i have BYC arms, 18's and a 4" BD.. and now a stock hood =)

Edited: 11/21/2007 6:58:09 PM by Slappy Mc Nasty

wait a damn minute here, on page 1 its been said "it has to be a 2001" and now on page 2 we have 2000................. WTF??"RLSN PSI" for the love of god, please throw up a close up pic, imma lose my mind trying to find a good clear pic

if you look up my name on s10forum I started a thread about it recently ...I have my intake mani I got from ebay for like 50 bux ...its out there...its alot easier than people may think

Edited: 11/21/2007 7:54:34 PM by Slappy Mc Nasty

s10 forums being all fucked up, you have a link??im just trying to get a 100% answer on years compatable. ive heard too many odds to make a purchase right now. needin help, trying to body my dime to the doors and this is greatly needed

http://www.s10forum.com/forum/f143/hoodie-hood-308452/

thanks for all the help but i have pretty much wasted my 20 posts this month on these searches and ended up with the same info as when i started......... good luck to all who add this intake, -PEACE-

well, i can tell you this, you cannot have a right hand drive s-10 and a cavilier intake................
i found one today, grabbed it and ran home, stripped off my stock intake and tried to lay it down in the new home. DENIED!! now i have a 2001 cavalier intake and out $100. i can get my money back but i thought maybe i could sell it to another fabricator. anyone in need of a cavi intake?
(red circle indicates hitting mark)
http://i14.photobucket.com/albums/a3...akemine004.jpg
(setting about 4-5" above its bolt in location)
http://i14.photobucket.com/albums/a3...akemine001.jpg
(just to high because of the steering shaft)
http://i14.photobucket.com/albums/a3...akemine002.jpg
(again, just to high due to the steering shaft)
http://i14.photobucket.com/albums/a3...akemine003.jpg

ok so which is it....? can i just go get one from a scrap yard? 2000 or 2001? my isuzu is a 97....answers would be nice...the right ones...