Anyone ever layed frame w/ 00-06 suburban?

I think I found all the info I was looking for.

Share the info.....

Originally posted by daburban



I think I found all the info I was looking for.

Just doesn't look proportional to me it would need to be sectioned also to look right. Or maybe just not so much. There's a silverado chopped 2" and it looks good actually its not over done.

Yep whats your plan? curious

Originally posted by

nyccustomizer



Share the info.....

Originally posted by daburban



I think I found all the info I was looking for.

his plan is to not share the info with you.....

ok we get how much you love that tahoe..

ya once is enough we get the hint

Holy shit

I highly disagree, post it like 6 er 7 times more, that thing is FUGGIN ILL!

haha

I just wanted to see what my options were since I have only seen one or two done and those were on forums, not in person. Eric Saliba from The Little Shop of Horrors gave me some info I was looking for. Since I want to run 24's and not shorten the axle, a panhard bar is out of the question. So I am going with a triangulated 4-link. My main concern was with the stock gas tank. It is huge, like 32 gallons. The tank is on the driver side and runs from under the drivers seat to right in front of the rear axle and it is up against the frame. The plan is to relocate a smaller fuel cell, 20 gallons or so, in the rear between the frame. I may raise the floor a few inches to make sure it is tucked up out of sight. Then I should have plenty of room to run a triangulated 4-link.

Just my taste, But I think the chopped top is fukin awsome in my sig. It is just a concept that if I ever did have the funds, I would get a reputable shop to perform the work. Thats just a lil more than I could handle.

`dont chop the top wont look right and good luck with baggin it