c10 z question

Of course mine are 2" drop spindles

also on setting up a trans crossmember im going to bolt in motor in mounts with trans hooked up but should the trans be level or what is the best way to set it up TO BUID CROSSMEMBER im a newbie and all help is appreciated thanks i have an angle finder also

i have a 79 c10 and i am actually using s10 cups in the front and i get an ass of lift. i believe i have 2 1/2 inch drop spindles (i bought em from a buddy for cheap) and i am running 15s with a 75 series tire and i lay the control arms hard!! haha im about to drag through em.. i dunno if that answers ur question or not.

i am in the market for spindles for my 78. i need to know if the 3" DJM spindles will accept 15 inch wheels or not?? it doesnt say anywhere on their site???

Edited: 9/6/2007 6:56:05 PM by oldskool86

if u run 3 inch drop spindles anything less than a 17 they rub BAD! i used the sd upper plate and air ride tech lowers. lays 22s with a 4 inch z. so ur question u can not run 15's with 3 inch drop spindles

i just reversed cupped my lowers 2 inches and now im laying control arms with 22;s with 265/35/22 and only need a 2 3/4 inch Z. i have 2 inch belltech spindles and plates on top with 7 inch slams
. hope this helps... and u will not lay rocker with just a Z. u will be pretty close to the pinch but rockers will be 2 inches at most from laying...

okay, so what inch drop spindle can you run and still use 15"s? And oldskool 86: when you did the 4" Z i assume you had to cut out the tranny tunnel and stuff and raise it how much?

porterbuilt street rods has a full crass member and it fixs all steering problems and will lay frame on 24"s with no z and is alos fully bolt on.

porterbuilt street rods has a full cross member and it fixs all steering problems and will lay frame on 24"s with no z and is alos fully bolt on.

yeah but its like $1200, and only accept air ride tech arms which are another $700 and then you have to get the corvette steering parts that they recommend using with it which are probably pricey also since you got to pretty much get them from GM.