S10 Brake booster and ABS box

ernie what did do to move the clutch master cylinder and where did u move it to

Originally posted by 89s dime



hey streetsweeper, what did u do with the linkage? mines hittin on my 90 S10 with a 3.5 traditionalFirst I cut the firewall, drilled new holes and frenched in the clutch booster. I shortened the linkage piece a little. The thing with doing this is it forces it in at a more drastic angle. If you cut too much out I wouldn

Originally posted by AVTekk



s10s only have 2 gens, square and round



but for the booster, run a first gen 9" JM5 booster, 7" off ebay, or hydroboost. metro works but im not a fan of it. your stock master will work with a 9" or hydroboost. the abs can be twisted forward 90

i moved it up and over i had to make a new mount inside the cab i used some 1x3 so i moved it up 3inches and i moved it over a lil bit to because my truck is set up for 22`s so i have a farily large tub so its over about 2 inches and up 3 to do it just cut it out of the stock spot and moved everything even the metal around it so it was easier on me i think there a pic in my profile if not ill put one in

also i had to section the wiper arm but my bd is 3.75 if you go anything less you wount have to move the clutch as much if at all

Ernie, What did you tub your firewall with?