Lets see some Hard line AIR set ups !

a good freind of mine

HARDLINE IS CLEAN -- I JUST WENT A BIT DIFFERENT AND DID STEEL BRAIDED -- CHECK THE PROFILE !!!

I have a question about stainless steel hardline. Do you have to have a special bender for 1/2" .049 wall tubing or can you just use a regular bender. I know there are benders out there that say they are for stainless tubing, but they cost double what a regular bender does. So is in necessary to get this bender or can I get away just getting a regular one?

Thanks,
Chad

I'm not sure you need sidewall as thick as .049 for air, but if you do use that then you will need a pretty beefy bending to bend .049 1/2".

well, that is all I can find. Nobody seems to have .035. I would rather run just what I need. Especially if I can get away with a regular bender at .035. Do you know who I could call about getting some line?

Thanks,
Chad

3/8"x .035,20ft lengths $2.92 per ft
Hose & Fittings Ect. 510-6610151,ask for Mike
This is anneled stainless,so is like polished.
Hope this is some help.

That would be good, but I need 1/2" and shipping would probably not be cheap. I have a supplier here, just trying to figure out the bender stuff.

Thanks,
Chad