K
any1 layin on stock spindles
Dupa102933
+1y
i went ahead and z'd the front frame 1 inch to lay out on my stocks
droppedmitsu
+1y
Originally posted by SunDown
Originally posted by rizz0
if your not layin cause your upper balljoint is binding then just cut the front of the control arm and adjust the angle of them a few degrees and weld them back up. you can do it with them still installed will take you all of 20 minutes to do both sides
DAMN IT, *smacking self*I dint think of that rizzo, good call. We just moved to a new house so I need to get 220 run and I will get that done. Just take a pie cut out of the upper or should both upper and lower be done?
you only need to do it to the upper control arms
Originally posted by rizz0
if your not layin cause your upper balljoint is binding then just cut the front of the control arm and adjust the angle of them a few degrees and weld them back up. you can do it with them still installed will take you all of 20 minutes to do both sides
DAMN IT, *smacking self*I dint think of that rizzo, good call. We just moved to a new house so I need to get 220 run and I will get that done. Just take a pie cut out of the upper or should both upper and lower be done?
you only need to do it to the upper control arms