anybody in AZ exp'd in hydros wanna make $$$?

305 views
15 replies
11 following
K
anybody in AZ exp'd in hydros wanna make $$$?
Hamed Hatch avatar
Hamed Hatch
+1y
i need somebody to come out and "finish" my civic for me. it's a simple prohopper 2p4d setup. by myself, i got to the point where everything's installed...solenoids, batts, cylinders, lines... i'm just SUPER effing frustrated with the leaks and bleeding process.

i'm crossing over from cans (see hatch in profile - gay), so when i see a quart of oil squirt from a fitting, my panties get all bunched up.

i just want this thing done...i'll supply the beer, and you name the price!!!
THE_CRUCK avatar
THE_CRUCK
+1y
Go see Kevin @ Just Plain Trick on Country Club and Guadalupe.
purpl7duece avatar
purpl7duece
+1y
Anyone help him out yet?
CRUISER-CH!X avatar
CRUISER-CH!X
+1y
or get a hold of brian from he did my juice and did a bitchin job!
IGotIssues avatar
IGotIssues
+1y
Hit up Brian and Aaron in They definately have the experiance and quality in Hydraulic installs
scrapinbyu avatar
scrapinbyu
+1y
yeah, kevin at just plain trick does a bad ass job. he did my wifes corolla aka CHKSRYDE, and i could not be happier. i have a few leaks here and there, but nothing major. but when u have juice, u better expect some leaks.
LaydRado368 avatar
LaydRado368
+1y
go to GrunionFabrication.com
juicedwagon avatar
juicedwagon
+1y
not to dog on anyone but a nice hydro settup will not leak. i had a leak problem with my fittings i got in my prohopper kit and i replaced them with all parker(including check valves) and after that i replaced the rev flow cylinders(worst things ever) with reg flows i have not had to mess with anything. im about due for replacing my cylinder seals though. just buy goodstuff and take your time and you will be good. air get leaks just like hydros btw. its just you cant buy crappy fittings with hydro's.

where is it leaking at?
Hamed Hatch avatar
Hamed Hatch
+1y
i redid the pumps and took care of the leaks...

but now i seem to have a grounding problem. my two pump mounts are seperate from my battery/solenoid rack. i think i need a common ground for everything, so i'm going to try running more heavy cable to tie everything together.

its wired by the book, plumbed by the book...but it just dosen't work right.

aaand i'm dead broke, so i won't be going to see anybody. i was hoping somebody could come out to me and show me some ropes, but it's all on me to sort this out now.
juicedwagon avatar
juicedwagon
+1y
use the body as the common groud. just make sure where your bolting your pumps to is clean.

is that the only reson it meeses up?