taco rocker

Mine lays rocker, no Z on the frame and 19s.

hidden, did you mess with the motor at all to get it to fit under the stock hood. that toyota bridge is nice

Is the front crossmember 1/2" or 3/4" lower than the frame rails? I had my frame on the jig table and swore it measured 3/4". Just wondering how an extra 1/2" bodydrop makes up the 3/4" difference.

Originally posted by aesthetikustoms



hidden, did you mess with the motor at all to get it to fit under the stock hood. that toyota bridge is nice

I didnt do anything to the motor at all. but I do have a hole in the hood for the power steering pump and resevoir. it could be sectioned and a stock hood put back on it. everything else clears.

the crossmember on mine was 3/4 of an inch lower then the frame. cut it horizontally at the welds along the sides of it and then sink the bottom that you cut off into the inside of the crossmember until it lays flat then weld it up. took me all of an hour start to finish. you will have to grind the rack and pinion racket and two bolts a little and it will lay out flat.

Hidden that is a bad ass ride. And those rims are sick.....can't find them anywhere anymore!

Tools to fix power steering resovoir clearance problem= 2x4 and sledge hammer....mine clears good now lol

my old taco with 20s

what kinda hood is that ^^^

thats the kind a cali boy made off a ranger edge hood grafted onto the stock hood.