M
driveshaft clearance
M
microscopic
+1y
i went from 16s to 18s and i already had to cut out the rear section of the cab for the driveshaft to clear and since i put the 18s on the driveshaft hits all sorts of nasty what do i do to fix th problem
whynotfab
+1y
Suicidedoors sells driveshaft tunnels, saw them in a recent MT.. different lenghts I think and should work
minipu95
+1y
this is true!
mmrcustoms
+1y
i just need to cut the cacb in the back and make one around a big pipe
D
draginzuzu
+1y
get a driveshaft from a 2wd rodeo its 2 piece, Thats what I used and didnt have to cut the cab at all, just have to make a carrier bearing support, no big deal
O
opie90
+1y
Originally posted by DRAGGINZUZU
get a driveshaft from a 2wd rodeo its 2 piece, Thats what I used and didnt have to cut the cab at all, just have to make a carrier bearing support, no big deal
You may have to cut it or extend it. Or go to any good driveline shop and have it turned into a 2 piece shaft
get a driveshaft from a 2wd rodeo its 2 piece, Thats what I used and didnt have to cut the cab at all, just have to make a carrier bearing support, no big deal
You may have to cut it or extend it. Or go to any good driveline shop and have it turned into a 2 piece shaft
blazed22s
+1y
notch the driveshaft.... j/k!
S
slamsuzu
+1y
Take out the seat and cut out the cab. Patch it back up with a tunnel or get some steel and make a tunnel yourself. Its real easy to do.