no room for 4 link

Originally posted by KAOSS



maybie i'm dumb, but are you adding seats in the bed?

um, technically, yes. But the bed floor is cut out and the back seats are gonna be the same height as the front ones, not just stuck on top of the stock bed. When I rebuilt the frame, I brought it straight back right before the notch, look at my profile.......

do a parallel 4 link outside the frame rails and run a pannard bar. Just keep your mounting points low. Mines been like that for 3 years no issues, just make sure the bars/mounting points are strong.

I guess another thing is that this isnt my daily driver. It will be driven to shows and on "nice" days, but I have other cars I drive everyday. So..... could I get away with running my front bottom bars under the seats and the top running reverse? I thought of maybe some kind of wishbone running forward where my driveshaft is, but its pretty tight. I wish i could just load up all my notes and sketches i have done and whatnot.......lol

i would run a parallel 4 link with a watts link setup. or everything forward triangluated with some custom mounts and some short bars on top. half reverse/forward is just stupid in my opinion.