K
what gauge steel
22dragn
+1y
what gauge steel should i use for a bed floor and sides? i'm only going to raise the bed floor about 2-3" and sheet everything else in.
1 LoWfUKn RaM
+1y
14-16 would do
eks10BDRG-N
+1y
did mine in 16guage
m2edragger
+1y
Originally posted by eks10BDRG-N
did mine in 16guage
yulp me too
did mine in 16guage
yulp me too
22dragn
+1y
would 18 be to thin
sjudd86
+1y
do 16 guage.
OSL
+1y
18 WOULD BE FINE,CHECK OUT MY PROFILE NO WARPING AT ALL
mccustomize
+1y
did you guys build a frame for it? or just the sheetmetal and what did you do to control the warping?
ShaveDnFlamed99
+1y
i would use 16 gauge and use 1/2" square tube and make a frame to make sure everything gets built square and to control warping
FluffyFreak
+1y
would 14 be good for the floor of a suburban too?