Dropping my 56 ford

So I have a 4 door 56 customline, I have some time this weekend. So I figure I might as well lower it finally. I havent seen any bolt in parts for the front I heard they make spindels but have had no luck. So Im just going to vut the coils. I know to trim a little at a time, but what would you advise for about a 3 inch drop? Out back Im going to take out a leaf and use a 3 inch block. Am I going to run into any problems? besides the bump stop maybe? Thanks guys

VICS22-UTM

check with fatman fabrication, im sure they have something for the frontend ... the rear if i remember correctly has 5 leafs, myself I would pull a couple, run a 2 inch block and some air shocks and whack the sheet out of the front coil

Try Classic Performance Products. They might have what you're looking for.
www.classicperform.com

the best way to drop it is off the back of a flat bed tow truck at my house.

i pulled the 2 shortest leafs on a 51 pickup and it dropped it 2 in...

He's got a Customline 4 DOOR. Not a truck.