parts for fuel cell??

301 views
14 replies
8 following
K
parts for fuel cell??
opie90 avatar
opie90
+1y
Check and see if 98 Frontier is Returnless or Return Check for Stock Location of Pressure Regulator. Oreilly and autozone Carry a In line Fuel Pump but you have to know the P/N I have them written down in the Shop. both about bill they will run @ 35 - 50 PSI (should be good for a most EFI) I have set them up on S-10's Return @ Returnless and Returnless Flex Fuel Rangers that Had the Regulator in the Factory Tank wich is a Pain Post your Finding (may need to PM me to remind me about P/N)
baggedhb avatar
baggedhb
+1y
mine should be about the same as ur frontier, i have a 96 hardbody. with a 15gal cell from summit, im using the Holley inline pump they sell, ull need a vent, return line, both will be on top of the cell, one of the 2 fittings on the bottom will be capped off the other goes to a fuel filter, then to ur fuel pump.
Street_Stylez avatar
Street_Stylez
+1y
Edited: 8/18/2005 8:32:03 AM by Street_Stylez

Is it possible to fit the stock sending unit and pump in a 15 gal cell from summit?? I was thinkin about buying a cell w/o sending unit and putting my stock shit in it.
bodydropped85 avatar
bodydropped85
+1y
30-45 psi is not enuf for that. get the MSD one from summit racing its 90 bux up to 120 psi
baggedhb avatar
baggedhb
+1y
yes, u can use the stock sending unit and stuff. ull probably have to shorten it tho, it will be to deep for the cell