Project...Been too damn long UPDATE PAGE 8
49882 views
183 replies
32 following
K
Project...Been too damn long UPDATE PAGE 8
2lowtoy
+1y
3in2out
+1y
Lookin good!
guilty by design
+1y
I didnt notice in the thread but how is the front clip modded to fit on the frame? I see the mounts are dropped but not the entire crossmember.
2lowtoy
+1y
The rad support is cut to fit at the bottom
guilty by design
+1y
Any specific reason?
lotoy86
+1y
dude thats bad ass
twisted minis
+1y
Some of the guys in my club do it this way and just make new bumper mounts. They say its easier.
guilty by design
+1y
Hmm, seems it would keep the radiator in the same location wich would conflict with the hood.
More than 1 way to skin a cat tho.
More than 1 way to skin a cat tho.
2lowtoy
+1y
no the rad still drops down with the support. Only problem is the bottom of the rad hits the crossmember for the strut rods. I had a new rad made shorter but with an extra core added.
Reason why i did it. was too damn lazy at the time to drop the whole damn front of the frame and do something with the strut rod mount. Back when i did it , there wasn't lower control arms like there are now available.
Reason why i did it. was too damn lazy at the time to drop the whole damn front of the frame and do something with the strut rod mount. Back when i did it , there wasn't lower control arms like there are now available.
2lowtoy
+1y
Heres a better pic to show ya how i have my Rad support